PRO and  LI'L PRO SERIES BASES
Universal Clamp Base - Designed to fit docks, piers, and Small Boat gunnels. Opens to 1 7/8".
Pro Series
1/2" diameter threaded center hole offers maximum holding power
Use with any Pro Series rod holder
Will not accept Li'l Pro Series rod holders
Accepts Lantern Holder
Li'l Pro Series
3/8" diameter threaded center hole
Same shape as Pro bases
Accepts any Li'l Pro Series rod holder
Will not accept Pro Series rod holders
Will not accept Lantern Holder 
NOTE: Left -thread rod holders require left-thread bases.   Add "L" to part number to denote left thread.  Example: 210-BL is a Li'l Pro Star Base, Left Thread

Star Base
Fits 2" or wider flat surface. 1/4" dia. mounting holes. Drill 3/16" dia. holes in boat when using screws. Use 1/4" dia. screws.
Flat Rail Base - For 1" or wider flat rails (ideal for pontoon boats). Can be used on any flat surface. 3/16" dia. mounting holes.
V-Round Base - Special V-shape on bottom allows base to be mounted on any size round rail or curved surface. 3/16" dia. mounting holes.
Flush Base - Low profile base mounts only 3/16" above surface for streamlined look. 1/4" dia. mounting holes.
Square Rail Clamp Base - For up to 1 1/4" square rails. Rod angle is not adjustable.
Hardware included.
Side Mount Base - Designed for Jon Boat gunnels where vertical holes can't be drilled. Easily bent in vise to fit difficult mounting locations. 1/4" dia. mounting holes.
Round Rail Clamp Base - Two models available for either 7/8" or 1" round rails. Rod angle can easily be adjusted by loosening one nut and turning base on rail. Hardware included.
Stainless Steel Round Flush Base
Flush mounts on 2.5" or wider flat surface. Brushed stainless steel finish.

  Star Base



Pro 200-B
Li'l Pro 210-B
Aluminum Trio Base
Allows rod holder to be mounted at 3 different angles, 0 , 25  and 50 degrees.

Trio Base



Pro #209-B
Li'l Pro #219-B
Stainless Round Flush Base






Pro #SSRB-0
Li'l Pro #SSRB1
Manning SC
(803) 473-4927
www.driftmaster.com
email: service@blackrivertools.com
Driftmaster BASES mount permanently to your boat or pier.  Rod holders screw into bases and can be easily removed when not in use.
NOTE: Left -thread rod holders require left-thread bases.   Add "L" to part number to denote left thread.  Example: 210-BL is a Li'l Pro Star Base, Left Thread

Stainless Square Flush Base






Pro #T-500-B
Li'l Pro #T-250-B
Stainless Steel Square Flush Base
3" Square base mounts flush.  (4) 1/4" mounting holes for extra strength.  Brushed stainless steel finish.